UK and EU Tariff Changes for 2027: What to Check Before 1 January

This article covers the tariff changes that take effect on 1 January 2027 in the United Kingdom and the European Union, and what importers and exporters should check before then.

In the United Kingdom, the tariff is not republished each year, but a large set of duty suspensions is being extended, created or allowed to lapse around the turn of the year, some of them removing duties of up to 16% on everyday goods. In the European Union, the Combined Nomenclature for 2027 adds new codes for wind turbine components, rare-earth magnets, lithium-ion cells and several types of scrap, republishes the entire tariff with current duty rates, and the EU’s own list of duty suspensions is due to change on the same date.

The practical question is the same on both sides of the Channel. Are the commodity codes in your systems, on your declarations and in your suppliers’ data still correct on 2 January?

The United Kingdom: duty suspensions change

The UK Global Tariff is not republished each year. Changes are made through statutory instruments during the year, and commodity code changes are announced as they occur. There is therefore no single “UK tariff 2027” to compare against. The changes that matter most around the turn of the year concern duty suspensions, which remove or reduce duty on specified goods.

According to the UK government’s guidance:

  • 269 existing duty suspensions are extended to 31 December 2028;
  • 23 suspensions end on 31 December 2026, for technical reasons;
  • around 90 suspensions due to expire in 2027 have a technical extension to 31 December 2027, and views on extending them further can be submitted until 3 February 2027;
  • from 26 November 2026, 101 agri-food products and kerosene are suspended until 31 December 2028, and certain fertilisers until 31 December 2027. The change is made by the Customs (Tariff and Miscellaneous Amendments) (No. 7) Regulations 2026 (SI 2026/1155) and covers 115 commodity codes. Goods originating in Russia or Belarus are excluded, so the suspension depends on origin as well as on the code.
  • the same regulations reduce duty to 0% on certain steel inputs under authorised use: nine commodity codes for steel used to make bright bar and wire, and six for steel used to make line pipe. The relief applies only where the steel is used for that purpose.
  • applications for new suspensions are open until 11:59pm on 3 February 2027.

The extended suspensions are not limited to food. They cover chemicals, plastics, hydrogen and automotive goods as well as food and drink, and the government estimates the saving to importing businesses at up to £155 million a year. The new agri-food suspensions remove duties such as 16% on baked beans, 12% on aubergines and 8% on chocolate.

For a business importing goods covered by a suspension, the financial effect is direct: duty saved on goods that benefit, and duty payable again from 1 January on goods whose suspension ends. Both depend on the commodity code being correct, because suspensions are granted code by code.

FOR FINANCE DIRECTORS

Duty suspensions change import costs on three dates. From 26 November 2026, new suspensions reduce duty to 0% on 115 commodity codes. On 1 January 2027, 23 existing suspensions end. By 3 February 2027, requests for new suspensions and views on extensions must be submitted. A suspension only applies when the commodity code declared matches the code on the list, and for some goods only when the origin qualifies. It removes the standard customs duty only: anti-dumping and other trade remedy duties still apply. Two questions are worth asking: who has checked the business’s import codes against the lists, and does the 2027 budget reflect the suspensions that end?

The Customs (Tariff and Miscellaneous Amendments) (No. 7) Regulations 2026 (SI 2026/1155)

Northern Ireland

Goods brought into Northern Ireland follow separate rules under the Windsor Framework. Goods considered “at risk” of moving into the EU are charged the EU rate of duty, so the EU’s 2027 Combined Nomenclature applies to them. Goods declared “not at risk”, for example under the UK Internal Market Scheme, are subject to UK rules instead. Businesses moving goods into Northern Ireland should check their codes against both tariffs.

The European Union: Combined Nomenclature 2027

The 2027 Combined Nomenclature is set out in Commission Implementing Regulation (EU) 2026/2163 of 17 September 2026, published in the Official Journal on 30 October 2026. It replaces Annex I to Regulation (EEC) No 2658/87 in full and applies from 1 January 2027. It matters to UK businesses that export to the EU, because their customers declare the goods under it.

The most significant group of changes creates new subheadings so that the EU can monitor specific trade flows more closely. The goods concerned are boneless beef cuts, PET flakes, bark, oak and beech sawlogs, ferrous scrap containing rare earths, aluminium scrap, wind turbine monopile foundations, wind turbine nacelles, rare-earth permanent magnets, lithium-ion cells and hard disk drive waste.

The pattern is clear. Most of these goods sit in clean-energy supply chains or in the recovery of critical materials, where the EU wants better visibility of what crosses its border. A new subheading does not by itself change the duty rate, but it changes the code that must be declared, and it gives customs authorities and statisticians a sharper view of the goods behind it.

The regulation also makes a set of narrower amendments:

  • the descriptions of CN codes 0302 89 31, 0303 89 31 and 0304 89 21 are updated following a change of scientific name for a fish species;
  • a supplementary unit for nitrogen content is added to twelve fertiliser codes in Chapters 28 and 31;
  • the wording of subheadings 6403 51 and 6403 91 (footwear), 7308 90 (structures and parts of structures) and CN code 8414 10 81 is clarified, and a new Additional Note 1 is added to Chapter 95 (toys, games and sports equipment);
  • the classification of ciclosporin in Annex 3 is amended following an opinion of the World Customs Organization’s Harmonized System Committee.

The EU’s own duty suspensions are also revised at the start of each year. A Commission proposal of 10 November 2026, which would apply from 1 January 2027 once adopted by the Council, adds 68 products to the list of suspended duties and withdraws 139, on which duty would become payable again.

The Combined Nomenclature is republished as a complete text rather than as a list of amendments, so no official document sets out, code by code, what has moved. Businesses have to identify the changes that affect them by comparing their own codes with the 2027 text. Some national statistical offices publish tables linking old and new codes, and these are a useful starting point where they exist. The ten-digit TARIC codes used for imports into the EU change on the same date.

Binding Tariff Information decisions deserve a specific check. Under Article 34(1)(a) of the Union Customs Code, a BTI decision ceases to be valid when it no longer conforms to the law because of an amendment to the nomenclature. A ruling on a code that has been split, deleted or redefined may therefore lose its effect on 1 January, even though its stated period of validity has not ended.

No period of extended use is available in this case. Extended use, which can allow a ruling to be applied to existing contracts for up to six months after it ceases to be valid, is excluded where the cause is an amendment to the nomenclature. The Commission’s guidance explains that such changes are published at least two months in advance, so holders are expected to obtain a replacement ruling before the new codes apply.

Why a changed code matters

In both territories, a commodity code is not an administrative label. It determines the rate of duty, whether a suspension applies, the product-specific rule of origin under each trade agreement, whether anti-dumping or other trade measures apply, and whether licences or other restrictions are triggered. A code that was correct in December can produce the wrong duty, the wrong origin rule or a missed relief in January.

What happens if the code is wrong after 1 January

The code and the duty rate that apply are those in force on the day customs authorities accept the declaration, not the day the goods were shipped. A declaration that uses a code deleted on 1 January is normally rejected, and the goods wait until it is corrected. A code that still exists but no longer describes the goods is often accepted, and the error appears later. Customs authorities can then recover the underpaid duty, generally up to three years after the import, and penalties may apply. A ruling that is no longer valid gives no protection. Where duty was overpaid, a repayment can generally be claimed within three years.

What to check before 1 January

The work is limited for many businesses, but it has to be done before the first declaration of the year rather than after it.

  1. Your duty suspensions. Check whether any goods you import into the UK or the EU are covered by a suspension that ends on 31 December 2026, or by a new suspension.
  2. Your product codes. Compare the codes held in your product data, your ERP system and any instructions to your customs agent against the current UK tariff and, for goods traded with the EU, the 2027 Combined Nomenclature.
  3. Your rulings. Check every Advance Tariff Ruling or Binding Tariff Information decision you hold, identify any that no longer match a valid code, and apply for a replacement before 1 January.
  4. Your origin positions. Where a code changes, confirm that the product-specific rule of origin you rely on still applies to the new code.
  5. Your suppliers and customers. Codes supplied by others, on invoices, supplier declarations or product specifications, need the same check.

Looking ahead: HS 2028

The larger change comes a year later. The next edition of the World Customs Organization’s Harmonized System, HS 2028, applies from 1 January 2028 and contains 299 sets of amendments. It was originally planned for 2027 and was postponed because of delays during the pandemic.

The changes reach well beyond this year’s update. Vaccines move out of heading 3002 into new headings, health-emergency goods such as ventilators and pulse oximeters receive their own codes, dietary supplements gain a dedicated heading, and the classification of plastic waste is restructured. Both the UK and the EU will need to transpose HS 2028 into their tariffs, and product-specific rules of origin will be re-indexed to the new codes. Shipments ordered in 2027 for delivery in 2028 may need to be handled under both sets of codes.

A business that reviews its codes now, and records how each was decided, will be better placed for the 2028 transition. The World Customs Organization publishes correlation tables linking the 2022 and 2028 editions, which are the natural starting point.

Where the codes in use have not been checked against the current tariff, a Customs Review can be limited to classification, with its scope and fee agreed before work starts.

Related articles

Customs Classification

Customs Classification Risk: How Tariff Code Errors Create Retrospective Duty Exposure

How an unreviewed commodity code becomes a retrospective duty demand, and what a governed classification process changes.

Read article →

Customs Classification

Customs Classification: What It Is and What It Decides

What customs classification is, how a commodity code is built, and the duty, origin, trade defence and relief positions the code decides.

Read article →

— DOES THIS APPLY TO YOUR BUSINESS?

We have on-the-ground expertise in the EU and in 25+ countries

A one-hour conversation is often enough to establish what this means for your specific trade flows. No pitch, no obligation.

●  Multi award-winning customs advisory firm   ●  WCO Academy partner   ●  Team France Export approved   ●  La French Tech Aix-Marseille   ●  Tech Zero member: net zero by 2030   ●  Pledge 1% member